Biketronics Hertz speakers true impedance
#1
Biketronics Hertz speakers true impedance
A few months back I installed the Biketronics Hertz speakers and I am now looking for an amp. After reading several reviews it seems that the RF PBX300 amp was providing the most bang for the bucks. However, the issue was that my speakers were rated by Biketronics at 3 ohms whereas the amp is rated at 4 ohms.
Therefore, I contacted Biketronics and asked them if I could use a 4 ohm amp with their 6.5" Hertz speakers. Following is their response:
"Hi Joe,
Yes, they test between 3.2 and 3.6 ohms so they are close enough to work. The mfg calls them a 4 ohm speaker.
Bill
Biketronics Customer Service
630 N Almon #140
Moscow ID 83843
(800) 735-2419"
So for anyone of you with the same issue we now have a resolution. I guess it is time to order my RF amp.
Therefore, I contacted Biketronics and asked them if I could use a 4 ohm amp with their 6.5" Hertz speakers. Following is their response:
"Hi Joe,
Yes, they test between 3.2 and 3.6 ohms so they are close enough to work. The mfg calls them a 4 ohm speaker.
Bill
Biketronics Customer Service
630 N Almon #140
Moscow ID 83843
(800) 735-2419"
So for anyone of you with the same issue we now have a resolution. I guess it is time to order my RF amp.
#2
Thread
Thread Starter
Forum
Replies
Last Post